I'm looking for information on how to enable the variable current limit
on this power supply. The one I have is fixed even with the built-in pot
wired up as in the manual at the Spellman Web site:

http://www.spellmanhv.com/tech/pdf/PCMMAN.pdf

There should be a way to make it variable, probably adding or moving a
resistor but the circuit board markings are no help.

Any info appreciated. I've beent to the Spellman Web site and sent them
a request for assitance twice with no reply.

Thanks.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.