DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Electronics Repair (https://www.diybanter.com/electronics-repair/)
-   -   Panasonic CT32SX31 power supply (https://www.diybanter.com/electronics-repair/133345-panasonic-ct32sx31-power-supply.html)

Johnace November 29th 05 02:55 AM

Panasonic CT32SX31 power supply
 
I have a panasonic in for repair. You have to push the power button
several times in order the get the relay to click. When it does I hear
a high pitch from the power supply and then nothing. I get no HV from
the flyback even for a second I hooked up my HV probe and get no
action at all.. It acts like shut down but I do not think so. I did
find an open 10 ohm resistor near the flyback but didn't make a
difference. I'm waitng for a schematic but haven't got one yet..Any
help on this? Thanks


Shoreline Electronics November 29th 05 03:30 AM

Panasonic CT32SX31 power supply
 
Check for shorted Horizontal Output Q551. Is probably is!

That open 10 ohm resistor is a sure sign of a classic PC failure for that
model. See these tips and I will also send you the schematic via
www.yousendit.com

Look for an email from them with a link to download.

---------------------------------------------------------------
Text pasted from WinSTIPS 2.0
http://www.ServiceSoftware.com
---------------------------------------------------------------

PANASONIC CT32SX31E

Pincushion Problem

Telrad Electronics

Is This Case C757, 6800pf/50v, P/N Ecqb1h682jm3 Was Shorted, About 1.2 Ohms
And R517 Was Open, 10k 1 Watt, Looks Like A 1/2 Watt But Is A 1 Watt. P/N
Erg1sj103p. R517 Is In The Abl Circuit Off Flyback Pin 3 And C757 Is Also In
The Abl Circuit Off Flyback Pin 3 But Is In The Pincushion Circuit Near
Ic750.

---------------------------------------------------------------

PANASONIC CT32SX31E

Pincushion Problem

Austin Tv & Electronics

Check C524 (.22) R517 (10k) Q702 (A1309) And R246 (1k Chip Cap)

Q702 Located Next To The Microprocessor On A Different Board. It Was The
Only 700 Number On That Board.

---------------------------------------------------------------

PANASONIC CT32SX31E

Pincushion Problem



Check C757

---------------------------------------------------------------

PANASONIC CT32SX31E

Pincushion Problems

Garris Tv - New Bern, Nc.

Check C524, R517 (10k 1watt), Q702, C757 And R246.
Q702 Located Next To The Microprocessor On A Different Board. It Was The
Only 700 Number On That Board.

---------------------------------------------------------------

PANASONIC CT32SX31E

Pincushion Problems 2



Ic750, C524, R517, Q751 All Defective

---------------------------------------------------------------

PANASONIC CT32SX31E

Shorted H.O.T, After 1 Min Pix Bowed On Sides

Bryn Mawr Tv

Shorted Q551 (2sc5517000lk) After Replacement Set Turned On With Full
Raster.
After 1 Min Sides Bowed Inward.
Found Shorted C557 (Ecqm1h6825v) Ic750 (Njm4565l Sub Ba15218n)
Open R517 (Erg1sj103p/ 10k 2watt) All Parts Are Off Abl Line
Replaced Fly As Precaution (Kft5aa369f)
Also Check C724, C755, D509, Q701, Q702, L551, L553

---------------------------------------------------------------




--
==========================
Jeff Stielau
Shoreline Electronics Repair
344 East Main Street
Clinton,CT 06413
860-399-1861
860-664-3535 (fax)

========================

"Johnace" wrote in message
oups.com...
I have a panasonic in for repair. You have to push the power button
several times in order the get the relay to click. When it does I hear
a high pitch from the power supply and then nothing. I get no HV from
the flyback even for a second I hooked up my HV probe and get no
action at all.. It acts like shut down but I do not think so. I did
find an open 10 ohm resistor near the flyback but didn't make a
difference. I'm waitng for a schematic but haven't got one yet..Any
help on this? Thanks




kip November 29th 05 02:39 PM

Panasonic CT32SX31 power supply
 
Replace HOT
Replace 10ohm
Replace the Pin Transistor
Replace the Flyback.
Replace the RH3F diode if there is one to left of flyback.
Then you are good to go...

Just done a 35 for the same thing..Maybe your is the same..Maybe

kip
"Johnace" wrote in message
oups.com...
I have a panasonic in for repair. You have to push the power button
several times in order the get the relay to click. When it does I hear
a high pitch from the power supply and then nothing. I get no HV from
the flyback even for a second I hooked up my HV probe and get no
action at all.. It acts like shut down but I do not think so. I did
find an open 10 ohm resistor near the flyback but didn't make a
difference. I'm waitng for a schematic but haven't got one yet..Any
help on this? Thanks




Johnace November 30th 05 12:29 AM

Panasonic CT32SX31 power supply
 
Thanks to all that responded.. I'll check them tomorrow.



All times are GMT +1. The time now is 01:34 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter