Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
ninthtoe
 
Posts: n/a
Default Infocus Projector intermittent failure

I have an Infocus LP400. It either works perfectly or fails to light
the lamp. Unable to determine whether it is the day of the week or
just it's mood that affects it. Have tried getting it going with data
signals and checking the lamp is firmly seated. Any advice welcome
thanks
  #2   Report Post  
 
Posts: n/a
Default Infocus Projector intermittent failure


ninthtoe wrote:
I have an Infocus LP400. It either works perfectly or fails to light
the lamp. Unable to determine whether it is the day of the week or
just it's mood that affects it. Have tried getting it going with data
signals and checking the lamp is firmly seated. Any advice welcome
thanks


Send it to Infocus for repair if they will still touch it.
Honestly, you are not going to be able to get any parts or service
information out of them for the unit. It could be a bad lamp, bad
ballast, bad main power supply, or a control signal problem.

  #3   Report Post  
carneyke
 
Posts: n/a
Default Infocus Projector intermittent failure

Go to one of the sites that sell bulbs (projectordoctor.com) and see if
the LP400 has bulbs listed. Some of these projectors had problems with
bulbs blowing up and the bulbs are no longer avaialable. Ususally when
you search for the model number and no bulb can be found, there is a
reason.

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
InFocus LP425Z power supply Jeff UK diy 2 October 4th 05 10:25 PM
Daewoo DVD composite out failure (DVG-5200S) Arfa Daily Electronics Repair 2 September 17th 05 10:51 PM
Heating and hot water failure Alex UK diy 3 September 12th 04 10:28 PM
gas hob flame failure sensor problems Tim Mitchell UK diy 0 August 31st 04 10:58 AM
21" monitor with FIMI chassis C2182DAS and High Voltage failure JSP Electronics Repair 0 July 12th 03 03:37 PM


All times are GMT +1. The time now is 10:19 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"