Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Convergence Problem - Mitsubishi 45" PTV Model # VS-45603
Hello:
I have a Mitsubishi 45" PTV Model # VS-45603 Chassis # VZ5 in my shop which has a convergence problem. The convergence is off Horizontally and vertically in all areas of the raster for all colors. The customer menu convergence adjustments do not move the crosshairs in any direction for any color. I am not familiar with this chassis and don't have service data for it. I have data and experience on the VZ2 chassis. This VZ5 chassis uses 2 STK392-110 ICs mounted on a board on the left side (As viewed from the rear) of the plastic tray. The signal board is in the middle, and the deflection/PS board is on the right. I have a data sheet on the STK392-110s from Sanyo, but I don't knwo what the proper voltages are for the pins. What are the common causes of this problem? Also, I would appreciate a scan of the convergence schematics and powers supplies for the convergence circuitry. Thank You! Robert McPherson Louisville, KY 502) 367-9324 OR (502) 298-6997 |
#2
|
|||
|
|||
Convergence Problem - Mitsubishi 45" PTV Model # VS-45603
Change those STK,s and check for open fuses close by.
kip wrote in message ups.com... Hello: I have a Mitsubishi 45" PTV Model # VS-45603 Chassis # VZ5 in my shop which has a convergence problem. The convergence is off Horizontally and vertically in all areas of the raster for all colors. The customer menu convergence adjustments do not move the crosshairs in any direction for any color. I am not familiar with this chassis and don't have service data for it. I have data and experience on the VZ2 chassis. This VZ5 chassis uses 2 STK392-110 ICs mounted on a board on the left side (As viewed from the rear) of the plastic tray. The signal board is in the middle, and the deflection/PS board is on the right. I have a data sheet on the STK392-110s from Sanyo, but I don't knwo what the proper voltages are for the pins. What are the common causes of this problem? Also, I would appreciate a scan of the convergence schematics and powers supplies for the convergence circuitry. Thank You! Robert McPherson Louisville, KY 502) 367-9324 OR (502) 298-6997 |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Mitsubishi VZ5 No convergence | Electronics Repair | |||
Mitsubishi 45" PTV Model # VS-45603 Chassis # VZ5 Convergence Problem | Electronics Repair | |||
Convergence Problem on a Samsung Projection TV | Electronics Repair | |||
New update: Toshiba TN50X81 convergence problem. | Electronics Repair | |||
Mitsubshi VS-5007 convergence problem | Electronics Repair |