InFocus LP425z power supply
I have an InFocus projection unit with a bad power suppky. I have fan action, and logic board action, ( 5v, 12v, 8.5v, -8.5v, but no 28 - 60VDC)
I assume that the 28 - 60VDC is the bulb voltage since I have no lamp lighting. Is there a particular component that I should be checking? Anyone have schematics for the following? NMB power supply SP1621 aka IFS p/n 520-0069-04 Thanks for your help in advance. I have access to soldering tools and multimeters. Jeff |
Schematics, not available.
Parts, not available. Call Infocus and if it is still a supported unit you can ship it to them for flat rate repair of around $250. If it is obsoleted by Infocus, time to start shopping. A very well experienced and trained technician might be able to repair it if the part failure is a standard part without any schematic. Infocus is factory exchange/repair only. At one time they had a few authorized independent repair shops in the US and you might be able to send it off to them. |
All times are GMT +1. The time now is 11:31 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter