DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Electronics Repair (https://www.diybanter.com/electronics-repair/)
-   -   Monitor shorted due to hair pin insertion to get full view of picture (EW Correction) (https://www.diybanter.com/electronics-repair/119232-monitor-shorted-due-hair-pin-insertion-get-full-view-picture-ew-correction.html)

Thaqalain September 1st 05 02:50 AM

Monitor shorted due to hair pin insertion to get full view of picture (EW Correction)
 
Philips 107X43: FCC ID: A3KM112

My monitor is shorted with a light while tilting board by placing paper

and metallic hair pin to adust EW Correction (a metal stud/upstand) to
get full view of picture otherwise it's left/right edges was bowed.
I checked fuse still working in another monitor,I inserted 2 other
fuse,but unable to get any picture.
Monitor shows green power LED and a humming sound while opening
monitors.
I want to know what went wrong during blow -off when I have pushed a
hair pin inside to lift board.What parts I have to look to rectify
monitor.


James Sweet September 1st 05 05:45 AM


"Thaqalain" wrote in message
oups.com...
Philips 107X43: FCC ID: A3KM112

My monitor is shorted with a light while tilting board by placing paper

and metallic hair pin to adust EW Correction (a metal stud/upstand) to
get full view of picture otherwise it's left/right edges was bowed.
I checked fuse still working in another monitor,I inserted 2 other
fuse,but unable to get any picture.
Monitor shows green power LED and a humming sound while opening
monitors.
I want to know what went wrong during blow -off when I have pushed a
hair pin inside to lift board.What parts I have to look to rectify
monitor.


Could be anything, you'll just have to look at where the pin shorted and
trace the circuit back testing parts along the way.



John G September 1st 05 08:58 AM


"Thaqalain" wrote in message
oups.com...
Philips 107X43: FCC ID: A3KM112

My monitor is shorted with a light while tilting board by placing
paper

and metallic hair pin to adust EW Correction (a metal stud/upstand) to
get full view of picture otherwise it's left/right edges was bowed.
I checked fuse still working in another monitor,I inserted 2 other
fuse,but unable to get any picture.
Monitor shows green power LED and a humming sound while opening
monitors.
I want to know what went wrong during blow -off when I have pushed a
hair pin inside to lift board.What parts I have to look to rectify
monitor.


It is very difficult to decipher your poor English but the most evident
point is
-- You do not know enough to be poking in a box that will kill you when
you do not know what you are doing.
--
John G

Wot's Your Real Problem?




All times are GMT +1. The time now is 09:14 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter