Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

 
 
LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1   Report Post  
komodore comrade
 
Posts: n/a
Default defroster heater, calculating resistence of replacement

hi there,

my fridge is icing up and when i looked inside i found its 23" defrost
glass tube heater shattered. it had a sticker stating 400w

i found a 12" replacement of around 30ohms for a few bucks which i
fitted. it iced up again and checking the heater i found it fused. part
of the element coil broke from excessive current.

what could be the problem? defrost thermostat? timer? resistence in
replacement heater too high? how can i calculate it properly? does
length of replacement heater make any difference to why it blew?

thanks

 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
AquaTherm Furnace - No Hot Water Issue David Home Repair 11 January 25th 18 08:44 PM
Water heater in series to use as storage tank ... good or bad? Fred Home Repair 12 January 29th 05 01:38 PM
Power cost of idle electric water heater Phil Sherrod Home Repair 57 April 2nd 04 10:51 PM
Poor hot water heater performance dperez@juno_nospam.com Home Ownership 3 October 24th 03 03:21 PM
Cost to install gas hot water heater Walleye Home Ownership 8 September 10th 03 03:20 AM


All times are GMT +1. The time now is 08:14 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"