Home |
Search |
Today's Posts |
|
Electronic Schematics (alt.binaries.schematics.electronic) A place to show and share your electronics schematic drawings. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to alt.binaries.schematics.electronic
|
|||
|
|||
Surprisingly simple push-pull driver
Values for about 50mA peak output. Idle current around 5/10mA. Yes, it
really is push-pull. With the 150mV saturation voltage, this is great for driving logic level complementary MOSFETs. They make some lovely SO-8 (and smaller) transistors that'll do 5A easily. Tim -- Deep Friar: a very philosophical monk. Website: http://webpages.charter.net/dawill/tmoranwms |
#2
Posted to alt.binaries.schematics.electronic
|
|||
|
|||
Surprisingly simple push-pull driver
Tim Williams wrote:
Values for about 50mA peak output. Idle current around 5/10mA. Yes, it really is push-pull. With the 150mV saturation voltage, this is great for driving logic level complementary MOSFETs. They make some lovely SO-8 (and smaller) transistors that'll do 5A easily. Tim Too bad the output is "floating". |
#3
Posted to alt.binaries.schematics.electronic
|
|||
|
|||
Surprisingly simple push-pull driver
"Robert Baer" wrote in message
net... Too bad the output is "floating". Howso? Tim -- Deep Friar: a very philosophical monk. Website: http://webpages.charter.net/dawill/tmoranwms |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Hack saw push or pull ? | Woodworking | |||
Push in -- pull out fastener ? | Metalworking | |||
Tip: Renovating pot with push-pull switch. | Electronics Repair | |||
Dukane 6V6 Push-Pull amplifier | Electronic Schematics | |||
Cobramatic push-pull guns? | Metalworking |