Thread
:
Are push fit plumbing fittings any good?
View Single Post
#
8
Andy Hall
Posts: n/a
On 26 Aug 2005 16:19:49 -0700,
wrote:
Andy Hall wrote:
The main thing is to follow the manufacturer's instructions.
This usually includes but is not limited to:
- Cut the pipe clean and square using a tubing cutter and not a
hacksaw
I don't buy this. When I started using plastic pipes I used a hacksaw
and trimmed of the pipe edge. As long as the cut is square all is fine
as the pipe indert isolates the pipe from the O ring as it is being
pushed on the pipe. For a few joints, using a hacksaw and some care,
and all is fine.
You are IMM and I claim my £5. He said exactly the same and ended up
with a flood.
Most, if not all of the plastic plumbing manufacturers explicitly tell
you not to use a hacksaw.
I use a £40 gun type pipe cutter as I now use lots of
plastic pipe.
These are good, I know, but the casual user can use a £5 pipe cutter
and get a good and correct result without bodging with a hacksaw
--
..andy
To email, substitute .nospam with .gl
Reply With Quote