View Single Post
  #2   Report Post  
Edwin Pawlowski
 
Posts: n/a
Default


wrote in message
ups.com...
Okay here's my problem. The kitchen sink faucet was leaking, so I was
going to install a new one. I shut off the water valves under the sink
(or so I thought). I twisted the hot and cold water handles to make
sure I'd properly cut off the water supply to both. No water came out.
So I started unscrewing the faucet handles, and then water started
running out of the faucet for about 3-5 seconds and then stopped. I
turned the valves back on to make sure my water still worked, and no
water came out of the faucet. Not only that, but my dishwasher doesn't
work now either. The motor runs, but no water. The water still works
everywhere else in my apartment, it's just the sink and dishwasher that
don't. Can anyone help?


It is possible that the valves you closed did not open again. They may be
corroded internally after years of non-use. If they are ahead of the
dishwasher fill line, that would be shut off also. If that is the case, the
water must be shut off at the main coming in and the valves replaced.

Something to try, can you push in the handles a little bit? If so, push in
and turn the valve counterclockwise to see if it opens.