"David Lang" wrote in message
k...
Hi
Having looked at the
edging strips available, the wooden ones are unsuitable for bending more
than a small amount over a long distance. The more flexible plastic ones
are
still not flexible enough for these spots.
You could try 'kerfing' the back of the wooden strip
http://www.cabinetmaking.co.uk/sawkerf.htm
Very much depends on the radius of the bend.
Dave
Cool idea - might get a more uniform finish which is easier to complete,
compared with lots of little cut pieces.
I'm going to try softening up a piece of plastic edging before I start, to
decide on the best route.