Thread
:
End Mills -- 2-Flute vs. 4-Flute?
View Single Post
#
16
Harold and Susan Vordos
Posts: n/a
"Pete Snell" wrote in message
...
wrote:
This is a dumb question, but what are the relative advantages of
4-Flute vs. 2-Flute end mills, and on what applications should one type
be chosen over the other?
Harry C.
2 flute can plunge cut, 4 flute cannot.
Not true. Center cutting 4 flute end mills are available. See above
comments on clearances for aluminum versus steel cutters. That, and chip
clearance, are the real issues.
Harold
Reply With Quote