Thread
:
cheap solder smoke filter or overkill?
View Single Post
#
17
Posted to sci.electronics.repair
Ralph Mowery[_3_]
external usenet poster
Posts: 286
cheap solder smoke filter or overkill?
In article ,
says...
Is there a good test to determine what mix a solder is? I came across pounds of
large diameter solder likely from a plumber. Not sure what old leaded plumbing
solder was. 50/50 by chance?
The best easy way it to check the melting point. Heat someting up and
measure the temperature then touch the solder to it. Raise the
temperature 10 deg F at a time . There are charts to tell the melting
temperature of the mixes. Most plumbing solder is the 50/50 mix and
usually too thick to do much electronic work.
Reply With Quote
Ralph Mowery[_3_]
View Public Profile
Find all posts by Ralph Mowery[_3_]