My bigger import lathe is not bad. I can dial stuff in by hand to about
3 tenths. The problem is under power the indicator needle turns into a
blur about 1.5-2 thousandths wide. For 99% of what I do that is fine,
but that other 1% is growing. Is the only answer to install a 3 phase
motor? I'm not completely against it, but its a bit of a job to move
the lathe, swap the motor, and reconfigure the controls. Not something
I can do in an afternoon.


--
This email has been checked for viruses by AVG.
https://www.avg.com