I've had better luck with Enco/MSC than ebay. All of Asia's production
rejects seem to go through Ebay.

Hul

Terry Coombs wrote:
On 2/5/2019 2:21 PM, Hul Tytus wrote:
Terry - Enco/MSC has a variety of taper to taper tools. Cost wasn't bad if
I remember correctly.

Hul


?? Yeah , I ordered one on ebay for about 12 bucks . Close inspection
revealed that when I cut from left to right the cut was convex , like a
barrel . Just the opposite cutting from r to l , concave . That one did
fit and hold , but it was just the ends that were in contact with the
chuck taper . That's OK though I can use that R8 adapter for another
project on down the line .

--
Snag
Yes , I'm old
and crochety - and armed .
Get outta my woods !