View Single Post
  #2   Report Post  
Posted to uk.d-i-y
GB GB is offline
external usenet poster
 
Posts: 4,768
Default best tool for this job?

On 08/11/2018 17:44, The Natural Philosopher wrote:
I am faced with masking filling and sanding plater/filler betweenÂ* oak
beams that have shrink

Its proving a monumental task, esp. the sanding

Mt orbital sander tears the masking tape and its prone to grind the ends
off the sheet of abrasive if it gets too close to a wall.

I bought a 'palm' sander from Wickes for £15 his morning,. It lasted 20
mins before the sanding pad fell off and the Velcro underneath got
buggered. I took it back and got a refund.


The job is as you can see here..

http://www.larksrise.com/Project%20P...4064881918.jpg

http://www.larksrise.com/Project%20P...n/DSC_0003.JPG


Any adviceÂ* welcomed.



1. Don't use masking tape, but something tougher? What do you have to hand?

2. Use better filler. I'm a huge fan of 1strike.
https://www.amazon.co.uk/Everbuild-O.../dp/B001326TJA

It says 'no sanding'. I'm not convinced about that, but you do just bung
it in the hole, and it stays put without sagging.

HTH