On Sun, 16 Sep 2018 15:21:29 +0100, nothanks wrote:

The problem with doing much more than drilling in a drill press is that
side load on the morse taper will make the chuck walk out of the socket.

I guess you could get around the severe radial loading by clamping the
knurling rollers 180' apart so the work piece is in the middle of them.
But the idea is a bit of a non-starter for other reasons.



--
This message may be freely reproduced without limit or charge only via
the Usenet protocol. Reproduction in whole or part through other
protocols, whether for profit or not, is conditional upon a charge of
GBP10.00 per reproduction. Publication in this manner via non-Usenet
protocols constitutes acceptance of this condition.