View Single Post
  #25   Report Post  
Posted to rec.crafts.metalworking
[email protected] dcaster@krl.org is offline
external usenet poster
 
Posts: 3,984
Default Drill Press Foot Switch

On Sunday, February 5, 2017 at 2:47:34 PM UTC-5, wrote:

You might need to think about this a bit more. Assuming you have a single phase motor, it will not reverse instantly. But if it is three phase , you just need the foot switch to swap two leads.

Dan

Right. But the motor still defaults to reverse rotation so all I would
need to do is step off of the switch, not toggle it.
Eric


But if you are using a single phase motor, it will not reverse until the centrifugal switch drops out.

Dan