Hi Fred,
Glad you liked it. The only thing to remember is that the bed extension only
has feet on one end. So the vertical board extends down an inch to level out
the bed. Just drill holes through the board and bolt it on. Secondly,
center the index head and insert a drive center. Bring it forward until it
hits the board. That is your center hole for the router base.

Be extra careful when using a router. The nova tool side cutter post is 1/2"
so it fits great in a router and cuts super clean. Enjoy.

-nick

On 7/25/04 6:51 PM, in article , "Fred Holder"
wrote:

Thanks for that picture Nick. My Nova Ornamental Turner sets on the shelf and
is
seldom used because it is sort of a pain to get it down and set it up on the
lathe for a few cuts or to cut threads that I can hand chase quicker than I
can
set up the ornamental turner. I've had mine for about four years and had never
thought of mounting it permenantly on a Nova 3000 Bed Extension. That makes it
an excellent stand alone tool.

Thanks again and glad you were able to sell yours.

Fred Holder
http://www.fholder.com