Thread: Ball Stud
View Single Post
  #5   Report Post  
Posted to rec.crafts.metalworking
Gunner Asch[_6_] Gunner Asch[_6_] is offline
external usenet poster
 
Posts: 10,399
Default Ball Stud

On Sat, 28 Sep 2013 14:02:48 -0700, "Bob La Londe"
wrote:

"Gunner Asch" wrote in message
.. .
On Sat, 28 Sep 2013 12:26:32 -0700, "Bob La Londe"
wrote:

"Larry Jaques" wrote in message
...
On Fri, 27 Sep 2013 16:40:38 -0500, wrote:

I have a power steering cylinder that one end mounts on a 1.125" ball
stud. Stud needs to be about 2" long and somewhere around 1/2"
diameter. I've busted up old ball joints and tie rod ends. Nothing the
right size. RV sway bar balls are 1.250". Suggestions or source?

Who made the p/s cylinder? Don't they sell them? As usual (for the
Web) the original question didn't contain enough info for people who
might want to help to know what you need.

"I have a yellow metal blurfl. What hardware should I use?"

A left handed framistat.


But only...only if it has converse threads! Stripping those suckers
is the kiss of death!


That's silly brainwashing by branding. An Adidas thread is just as good.


ROFLMAO!!!!!!!!!!!


"The socialist movement takes great pains to circulate frequently new labels for its ideally constructed state.
Each worn-out label is replaced by another which raises hopes of an ultimate solution of the insoluble basic
problem of Socialism, until it becomes obvious that nothing has been changed but the name.
The most recent slogan is "State Capitalism."[Fascism] It is not commonly realized that this covers nothing more
than what used to be called Planned Economy and State Socialism, and that State Capitalism, Planned Economy,
and State Socialism diverge only in non-essentials from the "classic" ideal of egalitarian Socialism. - Ludwig von Mises (1922)