Entertainment ctr finished
"Josepi" wrote in
:
1) I assume you are referring to the trimming process with the router
and that the perpendicular maintaining was a problem.
Correct
2) I often thought a hard rubber foam layer under a solid pressure
strip with multiple clamps might do the job for long edge gluing. Any
comments on that would be appreciated after your experience.
I did this minus the rubber foam - I used a piece of 2x and many Bessey
clamps. Even with their parallel jaws, I think I had instances where the
pressure was greater by one face of the plywood than by the other,
generating a small narrow glue gap on 1 side.
Mind you, I am quite pleased with my results, but it could have been even
better. I have also done some edging with the iron-on veneer tape. While
this may be a bit less desirable in terms of wear resistance, it is quite
acceptable visually. And easier, faster and cheaper.
--
Best regards
Han
email address is invalid
|