Thread: Hole spacing
View Single Post
  #91   Report Post  
Posted to rec.woodworking
Larry Jaques[_4_] Larry Jaques[_4_] is offline
external usenet poster
 
Posts: 9,025
Default Hole spacing

On Wed, 24 Aug 2011 22:26:42 -0400, "Mike Marlow"
wrote:

Bill wrote:
Eric wrote:


"Jack Stein" wrote in message ...

On 8/24/2011 2:10 AM, Bill wrote:
On 8/21/2011 10:39 AM, Twayne wrote:
On 8/23/2011 6:08 PM, Jack Stein wrote:

Just about any free CAD 2D program will do that for you including
Sketch-it or whatever it's called.

It's called Sketchup and I'm surprised Swing and Leon didn't
mention it.

I haven't read all of the messages before this one, so please
excuse me if this has been suggested. But why not build a *paper
model* (you don't need high-power computer software for this
problem).

There are lots of ways to solve this long standing problem, as this
thread has shown. You only NEED one of them.


"Give me a fish and I eat for a day, Teach me to fish and..."


No - it goes like this... Light a fire for a man and you keep him warm for
a day. Light a man on fire and you keep him warm for life...


Ewwwwwww! You're sick, perverted, and twisted.
No wonder we get along.

--
Knowledge speaks, but wisdom listens.
-- Jimi Hendrix