Thread: Hole spacing
View Single Post
  #13   Report Post  
Posted to rec.woodworking
Doug Miller[_2_] Doug Miller[_2_] is offline
external usenet poster
 
Posts: 289
Default Hole spacing

In article , "dadiOH" wrote:
Doug Miller wrote:

Then remeasure. You will find that:
- your block is 152mm long.


- you want a 6mm border at each end.


No he doesn't, he wants 1/4" and 6mm doesn't equal that. Close but no
cigar, so much for metric unless you can measure 6.35mm on that tape


Do you *really* think that 0.35 millimeters (less than 14 thousandths of an
inch) is going to be noticeable? Or are you just trying to be argumentative?

Had enough of that from SWMBO this past week, don't need it from you too.