View Single Post
  #7   Report Post  
Posted to sci.electronics.repair
N_Cook N_Cook is offline
external usenet poster
 
Posts: 5,247
Default Followup USB malfunction ? / Ezbus digital mixer /Ez-usb USB chip

Franc Zabkar wrote in message
...
On Sat, 22 May 2010 07:49:28 +0100, "N_Cook" put
finger to keyboard and composed:

Switching SDA line after 3 seconds still keeps the USB open but wrong
identity for the mixer firmware installer. Not had a chance to connect it

up
to a pc but I'm assuming it will not software connect if expecting the

mixer
VID/VID/endpoint. When next I have some time I will load the

installer.exe
into hex_reader_XVI32 and see if I can swap VID / PID hex-codes to fool

it
into thinking it is an EZbus rather than EZusb it is hooked to. Probably
checksummed there but simple enough to try.


You may be interested in IICUNI. It is a utility that controls I2C
devices from a PC parallel port. I suspect that you could program the
serial EEPROM in-circuit if you keep the EZ-USB chip quiet by holding
down its reset pin.

http://web.archive.org/web/200605110...ogs/iicuni.rar

I believe the EZ-USB datasheet should tell you how to compute the
checksum.

- Franc Zabkar
--
Please remove one 'i' from my address when replying by email.


I deRARified it and m/c translated the German readme.
3.1 and 95 , not NT, any idea if it would work under windows 98 ?