Remember that o-ring groove in that piston?
"Robert Swinney" wrote in message
...
Seems to me a drill press out of tram, even with a tilted table, would
only tend to drill larger
holes - not holes at the angle of tilt.
Run out will result in a larger hole... don't get me started on runout.
LOL. A drill bit tends to drill in the direction it is pointed.
Bob Swinney
"Bob La Londe" wrote in message
...
Well, I tried to assemble the hole thing and the push rod threaded into my
piston crooked... How is that possible I wondered. I did everything on
the
lathe. Oh, ****. No I didn't. My mini lathe was too small so I only
center drilled the piston on the lathe. I drilled it on the drill press.
I
really need to throw this damn thing away. The table was tilted side to
side. I straightened that today, but found the table is also slightly
tilted front to back. GACK!!! Its not horrible for punching holes in
sheet, but I guess I need to add a mill drill to my wish list for anything
else.
|