View Single Post
  #3   Report Post  
Posted to rec.crafts.metalworking
Snag[_3_] Snag[_3_] is offline
external usenet poster
 
Posts: 648
Default Screw extractor for brass 10x32 screw

Louis Ohland wrote:
I've already found out that a spiral screw extractor is not backing
out a snapped-off brass 10x32 screw.

Would a straight screw extractor work/. Available sizes seem to
start at .250 and up, while the 10x13 is roughly .156

Anyone make a straight screw extractor for #10 screws?


Left handed drill bit . Harbor Freight , around 6-7 bucks . BTDT , used one
to drill out a corroded idle jet in a Kawasaki carb ... spun that sucker
right out .

--
Snag
"90 FLHTCU "Strider"
'39 WLDD "PopCycle"
BS 132/SENS/DOF