Routing a groove length of a 2x4
On Mon, 5 Oct 2009 17:21:36 -0700 (PDT), "
wrote:
Seems to me that this is job for a router table.
Need to put a groove down the length of a small (less than 3 feet)
2x4. Was thinking I could do this by hand. It's a small groove. Not
more than 3/8 of a inch or so and only about 1/2 deep.
Thoughts, recommendations?
MJ
Tablesaw. Probably I would not bother with a dado blade, a few
passes and you're done. To perfectly center the groove, flip the
board.
|