Thread
:
Routing a groove length of a 2x4
View Single Post
#
2
Posted to rec.woodworking
Swingman
external usenet poster
Posts: 10,043
Routing a groove length of a 2x4
wrote:
Seems to me that this is job for a router table.
Need to put a groove down the length of a small (less than 3 feet)
2x4. Was thinking I could do this by hand. It's a small groove. Not
more than 3/8 of a inch or so and only about 1/2 deep.
Thoughts, recommendations?
MJ
Either a router table with a fence, or a dado stack in the table saw ...
depends on what you have.
Personally, I would go for the dado stack on the TS, but I'm set up to
do that quicker, but either will work.
--
www.e-woodshop.net
Last update: 10/22/08
KarlC@ (the obvious)
Reply With Quote
Swingman
View Public Profile
Find all posts by Swingman