mattathayde wrote:
mattathayde had written this in response to
http://rittercnc.com/metalworking/Dr...es-201627-.htm :
-------------------------------------
Michael Koblic wrote:
What is the expected tolerance of drill bits? I have a set of
fractional,
letter and number drills. No.12 to 15 (including 3/16") seem to
produce the
same size hole.
what are you measuring with, 12-15 range .18-.189, also do you have runout
on
your press, how fresh are the bits, etc. your dealing with such small
differences that it will be very hard to get a good read unless you have
very
high quality measuring devices.
-matt
##-----------------------------------------------##
Delivered via http://www.rittercnc.com/
Metalworking Forums
Web and RSS access to your favorite newsgroup -
rec.crafts.metalworking - 175567 messages and counting!
##-----------------------------------------------##
Any bit not sharpened properly--especially one with the point not
centered will drill oversize..