On 2009-08-16, Tim wrote:
"Larry Jaques" wrote in message
...
On Sun, 16 Aug 2009 09:04:30 -0700, the infamous "Steve Lusardi"
scrawled the following:
This is a piece of cake with a horizontal mill and the appropriate cutter.
[ ... ]
Pre-amateur miller me agrees with Steve that a horz mill will work
best in this case due to the angles involved. I don't recall seeing
too many sharply angled vert mill cutters.
Something like this: TinyURL.com/nyodas
I have seen them angled both ways.
There are also some made to cut both sides of a 'V' at once.
Or, you can mount a LH and a RH one face to face on an arbor to get your
'V' in a single pass.
Enjoy,
DoN.
--
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---