Milling a V-groove
"Larry Jaques" wrote in message
...
On Sun, 16 Aug 2009 09:04:30 -0700, the infamous "Steve Lusardi"
scrawled the following:
This is a piece of cake with a horizontal mill and the appropriate cutter.
Steve
"Frank J Warner" wrote in message
news:150820090827340286%warnerf@veriSPAMMERSDIEz on.net...
What sort of end mill do I need to mill a series of V-grooves in the
edge of a piece of steel?
The steel is annealed D2, S30V, or ATS-34, from .125" to .250" thick (a
knife blade), and I want to make a series of regularly spaced V-grooves
laterally along the edge or spine, like this:
/\/\/\/\/\/\/\/\
Will these be flattened for use as a thumb rest, Frank?
The angle does not really matter as I will be finishing these grooves
by hand with needle files. My objective is regular spacing with a
V-shaped notch or groove.
Sorry to be so dense but I am still learning some of the terminology
for these things.
Pre-amateur miller me agrees with Steve that a horz mill will work
best in this case due to the angles involved. I don't recall seeing
too many sharply angled vert mill cutters.
Something like this: TinyURL.com/nyodas
I have seen them angled both ways.
|