Peter wrote:
I am about to connect 4 inch waste from a new attic conversion to an
external cast iron one. Currently it rises to above roof level. Some
questions:-
As my angle grinder wont cut thro 4 inches should I cut twice ie make a sort
of inspection hole and hacksaw the back or is there an easier way. (for
direct connection at attic floor level)
Should I replace all to ground level or to existing 1st floor connections.
Will new plastic fit inside old cast iron joints.
If you can separate it at a joint, then it is easy enough to put plastic
into an old cast iron collar.
--
Cheers,
John.
/================================================== ===============\
| Internode Ltd -
http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/