View Single Post
  #7   Report Post  
Posted to rec.woodworking
Pat Barber Pat Barber is offline
external usenet poster
 
Posts: 844
Default Table saw switch

Get or make an angle bracket and mount the
electrical box to that and then add the switch.

The bracket could be a piece of flat steel
that's the correct width of the electrical
box.



Keith Nuttle wrote:

How would you install one of these switches ie. the paddle switch?

The shrouding around the guts of the saw is only about two thirds of the
table and my current switch fits on the underside of the other third of
cast iron table. The switch is about a finger length from the front edge
of the table.

The only other places the switch would fit would be quite low on the
legs of the support rack or way back under the table on the saw body.