ian field wrote:
A good flux is often handy too.

The strands in vehicle wiring are rarely tin plated and usually oxidised,
the flux in cored solder just makes a mess so I keep a tub of active
plumbers flux ready to hand.

Someone else mentioned the risk of vibration to soldered joints - heat
shrink sleeve reduces this risk significantly.


Very BAD idea. Plumbers flux is acid based and that is not what you want
on wires.

Ian Singer
--


================================================== =======================
See my homepage at http://www.iansinger.com
hosted on http://www.1and1.com/?k_id=10623894
All genealogy is stored in TMG from http://www.whollygenes.com
Charts and searching using TNG from http://www.tngsitebuilding.com
I am near Toronto Canada, can I tell where you are from your reply?
================================================== =======================