"R. LaCasse" wrote

|Why bother? Buy a butane powered soldering iron and be done with it.


I think I suggested that about a week ago!

Sounds good, if you plan on burning all the plastic around the
soldering area I'm considering with wind included...pretty messy
sometimes..


Not if you use your brain just a TINY bit.

You fire it up, let it heat to the proper useable temperature and the SHUT
THE FLAME OFF before you get near the plastic parts. Should be good for one
or two joints before the wind cools it off too much.
OR
The little catalytic flame only blows in one direction; once you figure that
out, you should be able to point it AWAY from the meltable parts........and
once it is up to temp. and you turn the "flame" down to a maintenance level,
there isn't that much heat coming out anyway.
OR
You could continue to whine over nothing.