Franc Zabkar wrote in message
...
On Mon, 11 Aug 2008 16:44:58 +0100, "N Cook" put
finger to keyboard and composed:
Absolutely nothing on the display, even in darkened room at switch off.
PDA/EHT of 7.2 KV and voltages at the CRT base of -1100 to -1750
Heater continuity . Extremely good blanking.
Anyone know where to get the pinning of the CRT
Misubishi 150CXB31T ? mitsubishichips no use
The block diagram on page 48 of the user manual ...
http://www.kikusui.co.jp/kiku_manual...0TM_41TM_E.PDF
... shows an anode voltage of 10kV. The cathode voltage is -1800V.
- Franc Zabkar
--
Please remove one 'i' from my address when replying by email.
I'd looked there but you must be better at translating
«???????»
*
?????????????????????????????????????????????????? ??????????????????????????
?????????????????????????????????????????????????? ??????????????????
*
?????????????????????????????????????????????????? ??????????????????????????
???????????????????????????????????????????
* ?????????????????????????????????????????PDF?????? ?????????
* ??????????????????????????????????
*
?????????????????????????????????????????????????? ??????????????????????????
than I am
I suspect something wrong in the intensity /Z axis control. 7KV etc should
give some sort of display , but with severe distortion.
--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/