Don't like poly glue much but do have uses for it once and awhile. Never had
a problem with it's strength myself. But then I just dampen one side of the
joint and only apply glue to the other side. I believe that is what the
directions on the container calls for and it works pretty well for me.

--
Mike G.
Heirloom Woods
www.heirloom-woods.net
"Gfretwell" wrote in message
...
OK I tried this stuff again. I was using hard maple, I wet it down good. I
glued both sides and seated a 1x2 into a 1/4" rabit that was a "tap in"
tight
fit. This was clamped overnight. The next day a light tap with a hammer
broke
the joint with absolutely no damage to the wood. I think library paste
would
have done a better job. Where did I go wrong? I can send pictures of the
bad
joint.