how do you suggest cutting a round hole in existing ceramic floortile
On Apr 22, 7:31*am, Norminn wrote:
clipped
Hey thanks to all for the great suggestions. I bought the 4 inch
diamond blade for a grinder but the idea of drilling holes interests
me. I may just try that first as the diamond wheel can always be
returned.
I thought about trying to use a chisel and break it but the hole must
cross two 13” tile and although it will be hidden by the cabinet, it
is within about 4” of the cabinet edge and I worry about cracking the
tile where it is exposed.
Bill, I have a rotorzip with the bit for tile but it is not
recommended for floor tile. I tried it but came to the conclusion that
at my age I would be gone before the hole was finished.
Again, thanks to all for the suggestions.
Ted
Just out of curiosity, why is the hole planned so close to the edge of
the cabinet? Can you not
put an angle on the exhaust to move it over? I would be concerned about
cracking the grout joint
in addidtion to cracking the tile, and with possibly sacrificing two
tiles rather than one.
We have tile put down by a wonderful contractor. Where the tile
surrounds railing anchors, they
cut the tile in half, cut half the hole in each half, and then laid them
such that the cut is invisible. It
would be worth contacting a contractor ... probably have the tools and
practice to do the job.- Hide quoted text -
- Show quoted text -
Thanks again to everyone for your suggestions and comments.
I tried drilling holes with the masonry bits but they did not work, at
least mine didn’t. The diamond wheel worked great and was fast.
Norminn, the hole is 3” from the edge of the cabinet and was placed
in that location to permit as much room in the cabinet as possible. It
is a small island with a cooktop grill and my wife wanted as much
storage as possible in the cabinet.
I build custom cabinets and furniture and also do some metalwork so
have a shop full of tools.
Thanks again.
Ted
|