View Single Post
  #1   Report Post  
Posted to alt.home.repair
Speedy Jim[_2_] Speedy Jim[_2_] is offline
external usenet poster
 
Posts: 205
Default Vexing plumbing problem

Dan Musicant wrote:

My kitchen faucet does the drip, drip drip thing.

I shut off the water at the cold water shutoff, remove the stem from the
hot water valve at the kitchen sink and see one, two or three tiny
grains of sand, flaked iron, who knows what it is, but it's very tiny.
The stem is part of a new faucet I bought for the kitchen sink, around a
year ago, and it's the old fashioned rubber washer kind, not ceramic. I
brush off the "grains" with an old tooth brush and put the stem back
together, open the water and no more drip, drip drip. I never get this
with the cold water stem.

Problem is, I have to do this again every few days, maybe not for 10
days if I'm lucky. Unless I want to live with the drip, drip drip (and I
don't).

I had my water service replaced around a year ago, being the line that
transmits cold water from the meter at the curb to where it attaches to
the house service, a stretch of maybe 60 feet. This was necessitated
because the plumbers who did a trenchless sewer line replacement found
the water service in bad shape, bad enough where it sprung a pretty bad
leak. They may have caused that leak but they wouldn't fix it for free
or even a reduced rate, claiming that it was so old and in such bad
condition (galvanized pipe), that it simply needed replacement. So, I
paid them to do it because their bid was actually pretty good ($2200,
IIRC).

My tank water heater (40 gallon) was replaced by an on demand Noritz
system (free, because I qualified for a city program, and this was their
first foray into tankless, and I was a willing participant). I don't
really care for the tankless, but that's off topic.

They put in some copper pipe from the tankless heater, but the line that
goes from there to my kitchen sink is around 30-40 feet of no-doubt old
galvanized pipe, and giving off sediment, presumably the rusting innards
of the pipe. I reasoned that this is what's causing the tiny particles
on the rubber stem washer problem and thought I'd measure, buy the 30-40
feet of galvanized pipe that would be needed to replace what's there now
and do it myself, now that the weather has warmed up.

But I got to thinking... what if this is caused by something else? All
that work and the expense of the new pipe would have been for nothing.
So I decided to post here first. Can I "safely" assume that replacing
that pipe would fix this problem? I have pipe wrenches, a hack saw, even
a jigsaw with metal blades. I have a propane (and Mapp Gas) torch, too,
but I have never sweated copper pipe, but figure if I just replace the
old galvanized with galvanized, I won't need to do that. I don't intend
to live here indefinitely. I'll be looking to sell the house and find
one that suits me better. Thanks for your input/ideas, etc.

Dan



I'll be surprised if it's flakes of rust from the galv pipe.

It might be solidified calcium deposits from the heater.

See if you can collect some particles and then pour a few
drops of muriatic acid over them. If there is frothing
and the particles pretty much disappear after a while, that
would indicate calcium/other minerals.

Jim