David Nebenzahl wrote in
s.com:

On 4/8/2008 4:31 PM Crabshell spake thus:

Can anyone tell me if a professional woodworking shop can rip a piece
of wood measuring 9" x 2" x 8' down to a 9" x .75" x 8'? Does this
type of rip have a unique name?

I think what you're describing is usually called "resawing", and is
typically done on a bandsaw. However, that's quite a thin slice you're
asking for there, kind of the equivalent of using a big-ass cheese
slicer on a 2" board. Very difficult to get a good cut. (It would
probably need to be run through a planer after resawing.) What are you
using this for? I assume it's not cheap pine and that you can't (or
don't want to) run down to the lumber yard and get an 8-foot 1x10.



It's Ipe wood and it's for a decorative plaque. The finished plaque needs
to measure 8.5"h x 17"w x 1/2"d (my original post said 3/4"). The only Ipe
I have found online that accomodates those dimensions is 9"h x 2"d, which
is way too thick. The finish has to be pristine being that it's
decorative.