"Bill Stock" wrote in message
-Free...
Old question,m I'm finally getting around to:

OK, I have two lights, two switches, both lights are on the same fuse. It
looks like both junction boxes have other circuits running off them, which
I think is the same fuse.

Plan is to run three way wire between the two lights white/red to socket,
blacks connected. Then run two way wire to the 1st switch white (black
tape) to red (socket) black to black. Then run three way wire bewtween the
two 3 way switches (white wire taped).

But I'm not sure if it matters which socket I run the switch to, since
they both have other circuits running off them. Can't I just run my other
circuits off the black/white in either junction box as it is now? This is
where it gets a little confusing.

TIA

Leave all the existing wiring the way it is. Run three wires between the two
switches. At one switch location disconnect and tape the existing wires that
were on the switch. Disconnect and tape the two wires that were on that
switch's light. At the first switch location you can remove the existing
single pole switch and now wire both three way switches to control that one
light. Last, you need to run a two wire cable from one light to the second