View Single Post
  #5   Report Post  
Posted to alt.home.repair
Ken[_6_] Ken[_6_] is offline
external usenet poster
 
Posts: 391
Default I plunged, I auged, I pulled the toilet! Hooray (chapter 3 of3)

Mike wrote:
The good folks of alt.home.repair have been seeing me through my
toilet crisis for a few days now, and I'm pleased to report that it's
fixed! To make a long story short, the most heavily used toilet in
our house started flushing slowly and backing up a few days ago. I
plunged and plunged to no avail. It was recommended that I try a
closet auger which I did and still, the problem remained. Several
people told me to pull the toilet and I admit, I was reluctant about
doing that as I've never done it before. Well, today I did it. I
pulled the SOB. I got all the water out, disco-d the water line and
then reached as far as I could into the toilet to see if I could feel
anything (and maybe save some trouble). Alas, I couldn't feel
anything in there. So I unscrewed the bolts from the floor and tilted
it up while looking down at the base. I saw something hanging out. I
couldn't tell what it was at first. I wiggled around and got to the
point where I could lean the entire toilet gently against the while
while I examined the bottom. As it turns out, it was a half-eaten
banana and it's peel. I think the banana would have gone down w/o the
peel, but the peel evidently got somehow tangled up and it wasn't
going anywhere without being pulled. I was relieved that the problem
was so easily solved. I then dragged the toilet out to the front yard
and went back in. I talked the wife into touching up the paint behind
the toilet (thanks to someone here for suggesting that) while I took a
hanger and worked over the holes around the inside of the rim (someone
else suggested that), Then I got all the old wax off the flange. I
went back outside and was hosing off the entire toilet when I decided
I wanted to put a new seat on it. (It's a hassle to install a seat on
this toilet while it's in place as it's close to a wall on one side).
So I popped up to Home D. and got a new seat (two actually, one for
the guest bathroom upstairs), got home, and put it on. At this point
my father-in-law helped me put the new wax seal on the bottom of the
toilet. He smashed it onto the toilet around the edges of the seal
using his thumbs and got a good seal on it. We carried it inside
together and seated it on the flange and gently rocked it back and
forth, then front to back. Then I put the bolts and tightened 'em up
a bit. The bolts (new ones that come w/ the wax seal) had a snap-off
piece as they were long, so I snapped off the top and, sadly, the
bolts are still too tall to snap the little bolt covers on. That's
the only hitch I ran into. I'll hacksaw more off those bolts at some
point in time. Anyway, I re-connected the water and invited the wife
to take it for a test drive (I requested #1 only, hehe). I said, call
me in so I can watch it flush. It flushed like a new toilet. I was
thrilled!

In closing, I'd like to thank all the folks here who gave me info,
advice, and in the case of Salty, a kick in the butt!

Mike


For what it is worth, a Dremmel tool is very good at cutting off the
excess length of the bolts. If you have one, it is much easier than a
hacksaw.