There are 2 part epoxy dispensers made which have a removeable vortex mixing
nozzle on the front of the materials cartridge, operated with air pressure
to dispense the required amount as needed, but they are rather pricey. An
ebay search may turn up a used unit. I would think there are some hand
operated epoxy dispensers like this for lower-level use, but I've never been
exposed to them, if indeed they do exist. Wait!Ahh! I found one. Link below.
It's 50 ml, but that was my first hit. You may find larger ones.



RJ

"Den" wrote in message
...
There's some machining involved so its almost on topic.

I've got a job on that needs to have about 100cc +/- 1cc of epoxy resin
mix poured into an assembly as a filler to make it up to the required
weight. The assembly has an open top 4" in diameter into which the resin
can be poured. The resin type, amount and housing design are all
non-negotiable as they are defined by the customer. Pot life IIRC is 20
minutes or so.

I've got a couple of hundred of these to do and figured someone here has
probably done something similar. Any clues on a tidy way to do it so I
don't end up with epoxy everywhere but where it's meant to be!

I'm thinking batches of 20 or so using cheap throw-away plastic jugs to
mix the resin in and then pour it into the housings while they sit on some
weighing scales. Any advice or suggestions on a cleaner or tidier
approach?

Thanks