On Thu, 21 Feb 2008 16:55:20 GMT, "Joe AutoDrill" wrote:
Anyone have a good reamer RPM chart?
I usually figure 2/3 of drilling RPM, but that's not always good enough.
For instance, .885" dia. reamer into steel, shallow process only 3/4"
stroke... I would normally run at 100RPM or so... But I'm guessing that is
ultra conservative for some of you.
The reamer is removing .010" material if it matters.
Regards,
Joe Agro, Jr.
I thought that the conventional wisdom was half the speed and twice the
feed-per-rev.
Mark Rand
RTFM