"Joe AutoDrill" wrote in message
news:Y1ivj.8755$_T3.267@trnddc07...
Anyone have a good reamer RPM chart?

I usually figure 2/3 of drilling RPM, but that's not always good enough.

For instance, .885" dia. reamer into steel, shallow process only 3/4"
stroke... I would normally run at 100RPM or so... But I'm guessing that
is ultra conservative for some of you.

The reamer is removing .010" material if it matters.

Regards,
Joe Agro, Jr.
(800) 871-5022
01.908.542.0244
Automatic / Pneumatic Drills: http://www.AutoDrill.com
Multiple Spindle Drills: http://www.Multi-Drill.com

V8013-R


Go to morse cutting tool's website. In their PDF catalog are some great
charts we downloaded this week.

http://www.morsecuttingtools.com/catalog.asp