Anyone have a good reamer RPM chart?
I usually figure 2/3 of drilling RPM, but that's not always good enough.
For instance, .885" dia. reamer into steel, shallow process only 3/4"
stroke... I would normally run at 100RPM or so... But I'm guessing that is
ultra conservative for some of you.
The reamer is removing .010" material if it matters.
Regards,
Joe Agro, Jr.
(800) 871-5022
01.908.542.0244
Automatic / Pneumatic Drills:
http://www.AutoDrill.com
Multiple Spindle Drills:
http://www.Multi-Drill.com
V8013-R