Fluke 79 acting up
This thing has performed flawlessly for many years, but when I turned it on
today something was not right. The ohms range flickers random readings, with
no probes plugged in I get around 230K on the display, or 2.22M, depending
on the range, which would imply that the problem is ahead of the scaling
circuit. When I switch to the low ohms range, the reading starts around 240
ohms and then drops to -0.00 over a period of 10 seconds or so, frequency
reading works, but AC volts reads 70mV when plugged into a 120V outlet.
Something strange is going on! I realized that I don't currently have a
backup meter, I suppose I could use this as an excuse to buy a true RMS
Fluke, I don't think I can bring myself to buy a cheapie, except perhaps as
a backup. Anyone run into this?
|