Phil Kangas wrote:
"Phil Kangas" wrote in message
Say you've laid out the end of a shaft for a center hole
to take a dead center and the hole comes out a bit off
center. How would you go about 'moving' the hole
back to center?
Phil Kangas


Guess I'd better add some more info on this. The bar is
1.75" 4140 B7 , rough finish surface, too big to pass
through
the spindle, 30" long, no extra length. I managed to do it
but
got curious what others would do.
Phil

Brass bush , steadyrest , and a very pointy lathe bit . And as Grant said ,
a PITA . I've been turning some 4140 lately , what fun !
Almost as much fun as the Ampco 18 ...
--

Snag aka OSG #1
'90 Ultra , "Strider"
The road goes on forever ...
none to one to reply