Sam Goldwasser wrote in message
...
OK, it's microcomputer controlled, so does that qualify as electronics
repair even if the micro isn't the problem?

This unit is about 19 years old and now has started leaking mostly
or totally when it's draining. The drain hose is in good condition
and is not obstructed. The water appears to be coming from the area
near the back of the horizontally mounted motor/pump assembly.
It's less than a cup of water for the entire wash cycle,
which a pan can easily catch, but of course these things will get worse.
I don't believe it's a hose or connection problem but can't rule that out.

Any info appreciated.

Thanks.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above
is
ignored unless my full name AND either lasers or electronics is included
in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.

Beware of leaking electricity.
I'm assuming you don't have access to the problem area. Dependent on how
close it is to a disposal job, I would cut an access hole in the adjascent
outer steel panelling and blank off with something aesthetic afterwards.
Put some of that U cross-section plastic "Flexiform" grommet strip around
the cut edge while playing around inside. I've done that with a washing
machine problem like this in an area behind large lumps of concrete that as
far as I could see were not removable.

Perhaps try query in uk.d-i-y, they like that sort of thing, and UK is no
more USA than water leaks are electronic ;-)

--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/