If you are installing one or two boxes in wood lathe, you could carefully
chisel through the plaster, find the wood and essentially mark the box
centered over one piece of lathe, cut that piece out completely and half of
the pieces of lathe above and below that piece. Now the box fits in the hole
and can be screwed to the remaining half pieces of lathe above and below.
This is best done slowly and with a sharp key hole saw. yes, it's a PITA. If
you are doing a renovation, and need to cut in lots of boxes, I'd use a raco
type "LB" bracket bang on box, either gem or 1900, which bangs on the front
of a stud, which is a much stronger and permanent job, but will require some
plastering. Here is a link to Raco boxes, scroll down to find LB bracket
boxes: http://www.hubbellcatalog.com/raco/R...?FAM=RacoBoxes




"BETAC-T" wrote in message
. ..
I have an old house with wood lath and plaster walls, and I need to cut out
a lot holes in the walls for light switches, electrical outlet receptacles,
etc.

Here is what I am doing now, and here is what the problem is:

I am just cutting them out by hand, one-by-one, using hand-held wallboard
saws, etc. The problem is that it is hard to keep the underlying wood
lath from vibrating and causing a wider area of plaster to crack and break
out. I have tried making sure each hole is adjacent to one of the studs so
at least one side of the hole has wood lath that is nailed down to the
adjacent stud. And, I have tried being very careful, cutting out a
little, reaching in to hold the rest of the wood lath stable, and then
carefully cutting the wood lath. But it is still a mess, doesn't work
very well, and takes a long time for each hole.

I don't think using any kind of powered reciprocating saw or saws-all
would help and probably would only make the lath vibrate more and damage a
wider area of plaster than using the by-hand method.

The problem seems to be the reciprocating action of the saws, so I keep
thinking there ought to be some kind of small circular saw that could be
used and plunged into the wall to cut the lath without vibrating it back
and forth. But I don't have, and haven't seen, a circular-type saw that
would be small enough to do this.

I have thought about buying one of those drill bits that supposedly can
saw sideways to cut holes in walls (which I saw on TV), but I haven't
found anything like that in any stores and I have a hunch they don't work
anyway (which is probably why they are only on TV).

So what the heck do professional electricians do? I keep thinking they
must have a tool or know of a trick to make this easy, especially since
they don't want to damage their customers' walls when putting in new
outlets, etc.

Any ideas? Thanks.